655 South Lincoln Ave San Bernardino Ca. 92408

Phone 877-470-2975 Fax 909-890-0703
Web address www.globalwest.net

Part # TS--46T ---- 1964-66 Mustang wheel side fender support and bump stop.

The kit includes the following:

• driver side mount

• passenger side mount

• hardware

• (2) bump stops (red) already installed

1. Jack the front of the car up and support it with jack stands.

2. Unbolt the wheel side tower support.

3. Install the new inner tower supports. The stock support would bolt on as seen in the photo to the left. The tubular support installs just as stock. There is a right and left unit. You cannot install them incorrectly. New hardware is supplied. 

 4.  Install all the bolts and nuts in the support loosely.  Place the head of the bolt in the engine compartment side.  Tighten down the top 2 bolts first and then move from the top down on the bracket. Tighten to 25 pounds.